Plumbing leads for the big jobs. Older homes due for a repipe, a water heater or a sewer line, with the owner’s name and a way to reach them.

Pick the ZIP codes you serve, keep the homes built in the years the bad pipe went in, and skip trace the owners for phones and emails. The list is yours alone.

That lead rang five phones. Yours was one of them.

1 homeownerWater heater replacement request, Charlotte, NC 28205

  1. Plumbercalled 0:40
  2. Plumbercalled 1:15
  3. Plumbercalled 2:30
  4. Youcalled 6:10
  5. Plumbercalled 9:45

Angi, HomeAdvisor

One homeowner. Up to five plumbers quoting the same water heater.

Who else gets it
Up to four other plumbers
You pay
About $40 to $80 a lead, booked or not
You reach
Whoever had a leak this week

Angi says it matches a homeowner with up to five pros. In 2023 an FTC order required HomeAdvisor to pay up to $7.2 million to settle charges that it misled contractors about its leads.

From year built to repipe estimates.

  1. 1

    Pull the older homes.

    Put in the ZIP codes you serve. Each home comes back with its owner of record, the mailing address, the year it was built and its value.

    An uploaded list in Locate after its rows were checked: 3,867 rows, 1,131 ready, 18 found by parcel number and 13 left out, with each owner, property address and the file’s own ID, and the actions Export and Start skip tracing. Owners and addresses are made up.
  2. 2

    Reach the owner before the pipe fails.

    Skip trace the list. Owners come back with phone numbers by line type and emails, and each number shows its Do Not Call status.

    A person sheet in Locate for Derek Oakley, 61: three phone numbers with their line type, two of them connected, two email addresses, two past addresses, three possible relatives and an associate with their own phones. One search with results. People, numbers and emails are made up.
  3. 3

    Fill the board with planned work.

    Export for your CSRs, your estimators or your mail house. Your columns stay, so the file loads into the CRM or dialer you already run.

    The exported CSV: the file’s own Lead ID, owner and address columns first, then Locate’s Locate Status, Contact Phone 1, its line type and Contact Email 1. Rows with no result or that weren’t traced stay in the file with the reason. Owners, numbers and emails are made up.

Aim at the pipe that is running out of time.

Show me homes built worth where .

3,867 homeowners in Charlotte, NC 28205

Homes shown are made up.

What $134 gets you. And what one repipe pays back.

  1. $134your first month, at most

    $49 for the plan, then $0.17 for each of 500 searches with a result.

  2. 500homeowners you can call or email

    That is 27¢ each, and no other plumber has them. One shared lead runs $40 to $80.

  3. $7,500one whole-home repipe, on average

    One sold repipe covers the list about 56 times.

  • Every homeowner in your ZIP codes
  • Line type and Do Not Call status on every number
  • One file for your CRM, dialer or mail house
Start free trialCancel anytime. A search with no result is free.

Send the offer that books the estimate.

Polybutylene pipe was made from 1978 to mid-1995, and galvanized pipe was common before the 1960s. Your list puts the year built on every card.

To 500 older homes on your list

Dogwood Plumbing

Your home was built in 1979. Do you know what your pipes are made of?

Free repipe estimate. We check the pipe, price the job and leave it in writing.

Repipe estimate(704) 555-0139

Derek Oakley
7618 Commonwealth Ave
Charlotte, NC 28205

Derek Oakleynow

Got your card. I think ours is the gray pipe. Can you come look?

At the door

“Hi, I'm with Dogwood Plumbing. Homes on Commonwealth Ave went up around 1979, and a lot of them still have the original supply pipe. We're doing free pipe checks this week. Mind if I take a look under the sink?”

  1. Monday500 cards land on your older streets
  2. WednesdayDerek texts you back
  3. ThursdayYour estimator checks the pipe
  4. FridayRepipe sold

A sample campaign. Locate builds and traces the list. You mail it, call it or knock. The homeowner, company, number, reply and week are made up.

Questions plumbers ask.

How can I get more leads for my plumbing business?

Build your own list. Pull the homeowners in your ZIP codes from county records, keep the homes old enough to need a repipe or a new water heater, and skip trace the owners for phones and emails.

What is the difference between shared and exclusive plumbing leads?

A shared lead is sold to several plumbers at once. Angi says it matches a homeowner with up to five pros. A list you build yourself is exclusive, because you are the only one who has it.

How do I find homes that need a repipe?

Filter by year built. Polybutylene pipe was made from 1978 to mid-1995, and galvanized steel was common before the 1960s. Year built is a signal, not proof, because the pipe may already have been replaced.

How do I get more water heater jobs?

Tank water heaters usually last 8 to 12 years. Mail or call the owner-occupied homes in your service area with a free check, and you reach the owner before the tank leaks.

What does it cost?

$49 a month. On top of that, $0.17 each time a search returns a phone or an email, which makes 500 homeowners $85 at most. You don't pay for a search that finds nothing.

Does Locate dispatch or book the jobs?

No. Locate builds and traces the list. Your CSRs, your dialer or your mail house do the rest.

Every older home in your service area is on a list.

Make it yours. 3-day free trial, then $49 a month.